6 General operation
40 FieldMan Narda
6.2.4 Changing the measurement settings in an
operating mode
6.2.5 Starting and pausing/stopping a
measurement
6.2.6 Changing the device settings
6.2.7 Exiting a submenu
6.2.8 Saving a measurement
✓ The desired operating mode is active.
⇒ Press SK2 , use the ▲▼ keys to highlight an entry, and use the ● key to select
it.
⇒ For information on the menus and functions, see the descriptions of the respective
operating mode.
Simplified representation
In the following descriptions, this simplified representation is used for changes in the
measurement settings:
⇒ MEASUREMENT SETTINGS: ... (corresponding action).
⇒ Press SK3.
⇒ Press SK4 .
⇒ For information on device settings, see 7 Device settings on page 43.
⇒ Press key.
⇒ Briefly press the key.
↳ A message confirms that the measurement has been saved.
⇒ To manage stored measurements, see 9 DATA LOGGER on page 91.
To Next Page
Loading...
