Native Instruments Maschine - Loading a Drumsynth into a Plug-In List on the Hardware

→
The Kick Plug-in is now loaded and is ready to be tweaked.
3.2.2.2 Loading a Drumsynth into a Plug-in List on the Hardware
1. Check that the CONTROL button is lit at the top left corner of your controller — if not,
press it to enter Control mode.
2. Press SELECT + pad 5 to select the Sound Kick Ektl A 2.
3. Press Button 3 to select the SOUND tab.
4. Press Button 6 to select PLUG-IN.
5. Press SHIFT + BROWSE to select a Plug-in.
If you would have pressed BROWSE alone here, you would have accessed the Browser. By
additionally holding SHIFT, you access the Plug-in menu instead!
6. Turn Knob 1 until the TYPE field is set to INSTR. and then turn Knob 2 until the VEN-
DOR field is set to INTERNAL.
The right display shows you the available MASCHINE instruments.
7. Turn Knob 5 to select KICK, and press Button 8 to load it.
8. Press SHIFT + BROWSE again to leave the Plug-in menu.
→
The Kick Plug-in is now loaded and is ready to be tweaked.
Building Your Own Drum Kit
Customizing Your Drum Kit
MASCHINE - Getting Started - 45