2. While holding the mouse button, drag your mouse up.
As the mouse cursor moves up, an insertion line appears at the places where you can drop
your Sound.
3. When the insertion line appears under the other kick, release the mouse button.
→
Your second kick takes place under the first kick in the Sound slot 2. It will now be trig-
gered by the pad 2 on your controller.
In a similar manner, you will now move the “Snare Ektl A 1” to pad 5:
1. Click and hold the Sound slot 3, which now contains the “Snare Ektl A 1.”
2. While holding the mouse button, drag your mouse down. When the insertion line appears
above the other snare, release the mouse button.
→
Your first snare takes place above the second snare in the Sound slot 5. It will now be
triggered by pad 5 on your controller.
Keep in mind that any change in the Sound slot positions also affects the pads trigger-
ing the corresponding Sounds! Hence, it is recommended you practice with your new
mapping to avoid confusion.
3.3 Save Your Work!
Again, it is recommended to regularly save your work. You can then open another Project or
close MASCHINE and take a break. Your tutorial Project will be recalled as is the next time you
open it.
To save your work in the MASCHINE Software:
Building Your Own Drum Kit
Save Your Work!
MASCHINE - Getting Started - 51
To Next Page
Loading...
Need help?
General
