1. Click the Osc2 label at the top of the Control area to select the Osc2 parameter page.
The Control area now displays the parameters of that page.
2. Click the fourth knob (Osc2Amp) and drag your mouse vertically to adjust the value.
You can fine-adjust the parameter value by holding down [Shift] on your computer key-
board while you drag the mouse!
5.5.2 Accessing the Plug-in Parameters using the Controller
1. Check that the CONTROL button at the top left corner of your controller is lit — if not,
press it to enter Control mode.
2. Press Button 3 to select SOUND.
This displays parameters for the selected Sound slot.
3. If the Sound slot 1 containing the “Analovue” Sound is not currently selected, select it by
pressing SELECT + pad 1.
4. Press Button 6 to select PLUG-IN.
The displays should now look like this:
→
You now have access to the parameters of your bass Sound “Analovue.”
To adjust any parameter from your controller, do the following:
1. Turn any Knob 1–8 to adjust the value of the parameter indicated right above in the dis-
plays.
2. Press the Page buttons (showing two arrows) at the left of the displays to switch to anoth-
er page of parameters.
Example
As an example, adjust the amplification level of the second oscillator in the “Analovue” preset.
Do the following:
Adding a Bass Line
Accessing the Plug-in Parameters
MASCHINE - Getting Started - 83
To Next Page
Loading...
Need help?
General
