2. Press button B to select the Group “Bass” containing the bass lines.
3. Press SELECT + pad 1 to select the Sound “Analovue.”
4. Press Button 3 to select the SOUND tab.
5. Press Button 6 to select PLUG-IN.
6. Press Button 7 or 8 to select the next free Plug-in slot.
7. Press SHIFT + BROWSE to select an effect.
If you would have pressed BROWSE alone here, you would have accessed the Browser. By
additionally holding SHIFT, you access the Plug-in menu instead!
8. Turn Knob 1 until the VENDOR field is set to INTERNAL.
⇨ The right display shows you the available MASCHINE effects.
9. Turn Knob 5 to select SATURATOR, and press Button 8 to load it.
10. Press SHIFT + BROWSE again to leave the effect selection.
→
The Saturator Plug-in is now loaded and is ready to be tweaked.
To load a Plug-in at the Group level, please follow the same procedure except at the
third step press Button 2 (GROUP) instead of Button 3 (SOUND). Similarly, to load a
Plug-in at the Master level (to process the audio of the whole Project), press Button 1
(MASTER) at this step.
Applying Effects
Loading Effects
MASCHINE - Getting Started - 92
To Next Page
Loading...
