VS1 Operations and Maintenance Manual Operating the transmitter
Issue 3.1 2013-10-01 Page 2-73
• Source: Use the up and down buttons to locate the desired audio source - AES, MPX, Ana-
log L/R
or Audio Player, then press the accept (checkmark) button to save the change. Press
the cancel (X) button to discard changes and return to the previous menu.
•
Stereo Mode: Use the up and down buttons to locate the desired stereo mode - Stereo,
Right Mono, Left Mono or L+R Mono then press the accept (checkmark) button to save the
change. Press the cancel (X) button to discard changes and return to the previous menu.
• Preemphasis: Use the up and down buttons to locate the desired preemphasis
characteristic - 0 us, 25 us, 50 us or 75 us, then press the accept (checkmark) button to save
the change. Press the cancel (X) button to discard changes and return to the previous menu.
• Low Pass Filter: Use the up and down buttons to toggle between ON or OFF, then press the
accept (checkmark) button to save the change. Press the cancel (
X) button to discard changes
and return to the previous menu.
•
Input Levels: Use the up and down buttons to move the cursor to the desired audio input
and then press the right button to enable editing of the parameter. Figure 2.57 on page 2-74
shows all the editing screens for the Input Levels sub-menu. Within any of the editing
screens, use the up and down buttons to edit a parameter value, noting the minimum and
maximum limitations indicated at the bottom of the display. When complete, press the
accept (checkmark) button to save the change. Press the cancel (X) button to discard changes
and return to the previous menu.
• Audio Player: Use the up and down buttons to select File Playlist or Stream 1 through
Stream 255, then press the accept (checkmark) button to save the change. Press the cancel
(X) button to discard changes and return to the previous menu.
• Gain Adjust: Use the up and down buttons to select again adjust level between -20 and 10
dB (in 0.01 dB increments), then press the accept (checkmark) button to save the change.
Press the cancel (X) button to discard changes and return to the previous menu
To Next Page
Loading...
