NCR 7167 - Page 116

7167 Owner’s Manual Chapter 6: Commands
November 2003
103
Close Form
ASCII:
DC1
Hexadecimal:
11
Decimal:
17
Closes the feed roller and platen and retracts the forms arm stop to the forms stop
position. If the printer is reset or the Clear command (0x10) is received, the feed roller and
platen are opened.
This command executes if the platen is already closed. This command is processed
regardless of which station is selected.
Example:
MSComm1.Output = Chr$(&H11)
Open Form
ASCII:
CAN
Hexadecimal:
18
Decimal:
24
When the printer is in 7156 Emulation Mode or in non-Page Mode, this command opens
the feed roller and platen so that a form may be inserted (default position).
This command has the same code as the Cancel Print Data in Page Mode command, which
is only executed in Page Mode.
This command executes if the platen is already open. This command executes (opens the
feed roller and platen) regardless of which station is selected.
Example:
MSComm1.Output = Chr$(&H18)