NCR 7167 - Page 168

7167 Owner’s Manual Chapter 6: Commands
November 2003
155
Select Bit Image Mode
ASCII:
ESC * m n1 n2 d1 ... dn
Hexadecimal:
1B 2A m n1 n2 d1 ... dn
Decimal:
27 42 m n1 n2 d1 ... dn
Sets the print resolution and enters one line of graphics data into the print buffer. Excess
data is accepted but ignored. Any print command is required to print the data, after which
the printer returns to normal processing mode.
See the illustration graphic representation of the bit image.
In 7156 Emulation
Mode, slip graphics are only 7- bit (MSB not printed.) In 7158 Native
Mode and 7167 Native Mode., slip graphics are 8-bit.
Values:
Receipt Station
Value
of m
Mode
No. of Dots
(Vertical)
No. of Dots (Horizontal)
Number of
Dots/Line
0 8 Dot Single
Density
8 (68 DPI) 0-288 (101DPI,
80mm)
0-212 (101DPI,
58mm)
8x288 (80mm)
8x212 (58mm)
1 8 Dot Double
Density
8 (68 DPI) 0-576 (101DPI,
80mm)
0-424 (101DPI,
58mm)
8x576 (80mm)
8x424 (58mm)
32 24 Dot Single
Density
24 (203 DPI) 0-288 (101DPI,
80mm)
0-212 (101DPI,
58mm)
24x288
(80mm)
24x212
(58mm)
33 24 Dot
Double
Density
24 (203 DPI) 0-576 (101DPI,
80mm)
0-424 (101DPI,
58mm)
24x576
(80mm)
24x424
(58mm)