NCR 7167 - Page 210

7167 Owner’s Manual Chapter 6: Commands
November 2003
197
Select Print Direction in Page Mode
ASCII: ESC T n
Hexadecimal: 1B 54 n
Decimal:
27 84 n
Value of n:
Start position
0 Upper left corner proceeding across page to the right (A)
1 Lower left corner proceeding up the page (B)
2 Lower right corner proceeding across page to the left (upside
down) (C)
3 Upper right corner proceeding down page (D)
A, B, C and D note the direction of of print. See illustration.
Selects the printing direction and start position in Page Mode. See the illustration.
The command can be sent multiple times so that several different print areas, aligned in
different print directions, can be developed in the printer’s page buffer before being
printed by the Eject Slip command (0C).
A
D
B
Default: 0 (Upper left corner proceeding across page to the right)
Example:
MSComm1.Output = Chr$(&H1B) & Chr$(&H54) & Chr$(n)
Exceptions:
This command is valid only in Page Mode.
This command is ignored if the value of n is out of the specified range.