NCR 7167 - Page 336

7167 Owner’s Manual Index
Novembery 2003 Index
320
Communication interface. See RS-232C interface
Communication interface modes, 58
Configuring the printer, 56
Connecting cables
cash drawer, 8
communication, 8
power, 8
Connector
cash drawer, 80
RS-232C communication, 77
Consumables. See Paper
Contacting a service representative, 45
—D—
Data
moving through buffer, 174
Datascope modes
setting, 61
Default code page, 70
Default lines per inch
setting, 65
Density, of print, 255
Diagnostic modes, 60
Diagnostics, 53
knife failure, 42
level 0, 53
level 1, 53
level 2, 73
level 3, 74
paper jam, 42
paper out, 42
printhead over/under temperature, 43
startup, 53
Dimensions, of printer, 4, 255
DIP switches. See Switch settings
Documentation
ordering, 8
DOS
sending commands, 75
Dot patterns, of characters, 257, 258
Double-wide characters
dot patterns, 259
DTR/DSR protocol, 77
Duty cycle
limitations, 256
—E—
Emulation/software options, 64
Environmental conditions, 254
Errors. See Problems
—F—
Features, 2
Flash download
commands, 247
Flash download commands, 247
Forms
ordering, 7
printing, 17, 40
—G—
Graphics
commands, 152
Graphics commands, 152
—H—
Hardware options, 67
Horizontal positioning commands, 125
—I—
Installation
choosing location, 4
connecting cables, 8
loading paper, 11, 39
removing packing material, 3
setting switches, 6
turning on the printer, 10, 39
Interface. See RS-232C interface
—K—
Knife
failure of, 42
setting, 68
—L—
LED (green) blinking (fast)
what to do, 42
LED (green) blinking (slow)
what to do, 42
LED (green) does not come on
what to do, 41
LED (slip table) does not come on
what to do, 44
Level 0 diagnostics, 53
Level 1 diagnostics, 53
asian mode, 65, 66
carriage return usage, 65
check flip option, 69
check flip test modes, 62
color paper option, 59, 60, 64, 67, 69, 70, 72
communication interface modes, 58
configuring the printer, 56
datascope modes, 61
default code page, 70
default lines per inch, 65
diagnostic modes, 60
emulation/software options, 64
hardware options, 67
knife option, 68
maximum power option, 67
MICR option, 69
MICR test modes, 62
paper low sensor, 68
paper width, 68
platen waiting time, 66
print density, 67
print head gap adjustment test modes, 63
printer configuration, 54