NCR 7167 - Page 99

7167 Owner’s Manual Chapter 6: Commands
November 2003
86
Hexadecimal Command
Code and Operands
Command Name
Page
1B 61 n Select Justification 130
1B 63 30 n Select Receipt or Slip for Printing; Slip for
MICR Read
106
1B 63 31 n Select Receipt or Slip for Setting Line Spacing 108
1B 63 34 n Select Sensors to Stop Printing 109
1B 63 35 n Enable or Disable Panel Buttons 110
1B 64 n Print and Feed n Lines 123
1B 63 37 n Enable or Disable Slip Paper End Feeding Stop
111
1B 65 n Print and Reverse Feed n Lines 123
1B 66 m n Set Slip Paper Waiting Time 112
1B 69 Perform Full Knife Cut 104
1B 6A k Read from Non-Volatile Memory 214
1B 6D Perform Partial Cut 104
1B 70 n p1 p2 Generate Pulse to Open Cash Drawer 113
1B 72 n Select Print Color 148
1B 73 n1 n2 k Write to Non-Volatile Memory (NVRAM) 214
1B 74 n Select International Character Set 146
1B 75 0 Transmit Peripheral Device Status 164
1B 76 Transmit Printer Status 164
1B 77 01 Read MICR Data and Transmit 203
1B 77 46 Check Flip 212
1B 77 50 Define Parsing Format, Save in NVRAM 204
1B 77 52 Reread MICR Data 203
1B 77 70 Define Parsing Format, Do Not Save
Permanently
204
1B 7A n Select or Cancel Parallel Printing Mode on R&J 114
1B 7B n Select or Cancel Upside Down Printing Mode 148
1C Select Slip Station 114
1C 21 n
Select print modes for Kanji characters
221
1C 28 67 pL pH 28
Scanning Threshold
225
1C 28 67 pL pH 29 Scanning Area
226
1C 28 67 pL pH 32 Compression Mode
226
1C 28 67 pL pH 38 Deletes Cropping Area
227
1C 28 67 pL pH 39 Set Cropping Area
228
1C 28 67 pL pH 3C Transmission Format
229
1C 28 67 pL pH 50 Transmits Threshold Level
230
1C 28 67 pL pH 51 Transmits Scanning Area
231
1C 28 67 pL pH 5A Transmits Compression Method
232
1C 28 67 pL pH 61 Transmits the cropping area
233