NCR 7197 - Windows Command Line Firmware Update Utility

Chapter 7: Reflashing the Printer Firmware 7197 Owner’s Guide
February 2002
184
Windows Command Line Firmware Update Utility
The Windows Command Line version of the Flash Utility is provided to allow batch mode
of operation in a Windows 95/98/NT4/2000 environment. If you issue a call to
TseFlash.com with the /? parameter you will get the following out put that explains the
parameters.
NOTE: This utility requires the TseFlash.exe to be in the same directory. TseFlash.com
is just a shell that sends the command line options to TseFlash.exe to process.
*** TseFlash.com Ver 1.03 ***
Thank you for using TseFlash Flash Memory Writer command line
interface utility!
Please wait...
Status: /? detected!
TseFlash [model] [download type] [COM] [baudrate]
[parity] [stop] [filename]
/K590 Select K590 printer.
/7167 Select 7167 printer.
/7197 Select 7197 printer.
Selections for the download type:
/m Download firmware main program.
/i Download firmware IPL program.
/a Download ANK sigle byte font.
/s Download ASIAN two byte font.
/rs Download receipt ASIAN two byte font.
/ss Download slip ASIAN two byte font.
Selections for the COM port:
/COMX Where X is any valid integer within 1~20.
Selections for the baud rate:
/[115200] | [57600] | [38400] | [19200] | [9600] |
[4800] | [2400] | [1200]
Selections for the parity bit:
/[none] | [even] | [odd]
Selections for the stop bit:
/[1] | [2]
Selections for the filename:
Any valid binary file with extension *.mfw | *.sfn | *.dfn |
*.ipl.
If you fail to use the correct parameters an error message will be displayed similar to the one
below.
Error : Too few / many command line parameters!
The following is an example of a command line: