NEC DECT G355 - Installing Belt Clip on I755; Attaching Belt Clip to I755 Handset

Handset accessories
200
To uninstall the belt clip, perform the following steps:
1. Place the handset facedown on a flat surface.
2. Use the plastic tool to unlock the belt clip fastening.
3. The plastic tool is shipped in the box with the handset.
4. Slide the belt clip upward.
5. Remove the belt clip.
6. Remove the plastic tool.
7. Install the belt clip compartment cover as shown in Figure 17:
Installed belt clip compartment cover.
Figure 17: Installed belt clip compartment cover
CAUTION
Only use the plastic tool that is shipped with your
G355/G955 to unlock the belt clip or the belt clip
compartment cover. Using anything else) like a
screwdriver can damage your DECT handset.
Dit document wordt u aangeboden door TelecomHunter. Dé zakelijke Telecom webshop.
T 088 7463 444 | @ sales@TelecomHunter.nl | www.TelecomHunter.nl