3-34 DT900/DT900S Series Phone User Guide
Figure 3.6 Handset Connection
To connect LAN cable to the phone
You will need a 10 BASE-T/100 BASE-T/TX LAN cable (Straight) to connect the
phone to your network.
1 Connect the 10 BASE-T/100 BASE-T/TX LAN cable to the LAN port on the phone and to
an open port on a device such as a Hub or PoE (Power Over Ethernet) switch on the
local area network.
2 Thread the LAN cable through the groove on the bottom of the tilt leg.
Figure 3.7 Phone/LAN Connection
IMPORTANT NOTE ON USER SETTINGS FOR THE
DT930 (ITK-8TCGX) AND THE DT930S (ITK-32TCGS)
The DT930 (ITK-8TCGX) and the DT930S (ITK-32TCGS), use a different option for
User Settings than all of the other models documented in this manual that use Option
3 for User Settings.
The ITK-8TCGX and ITK-32TCGS phone models use
1 User Settings.
To access User Settings on the ITK-8TCGX and ITK-32TCGS
1 Press the Menu key.
2 Select the Multi settings icon.
To Next Page
Loading...
