. . . . .
DT900/DT900S Series Phone User Guide 3-35
Figure 3.8 Multi settings icon
3 Press the Settings icon.
Figure 3.9 Settings icon
4 Select 1 User Settings.
To connect a headset (Optional)
Note: For information on connecting a Jabra Bluetooth headset to your phone, refer
to the Bluetooth Support chapter in this manual.
1 Press the Menu key on the phone.
2 Select 3 User Settings.
3 Select 2 Headset.
4 Select 1 Enable/Disable.
5 Select 2 Enable.
6 Press Enter b on the cursor pad or the OK softkey to accept the setting.
7 Insert the headset cord plug into the HEADSET connector on the back of the phone, until
you hear a click.
Figure 3.10 Headset Connector
To connect a computer (Optional)
Note: Any devices connected to the phone’s PC port will momentarily disconnect
from the network when the phone is rebooted, or if disconnect if there is a loss
of power to the phone.
You can connect a computer to the network through the phone using a LAN cable if
there are a limited number of available ports on your local area network.
To Next Page
Loading...
