1. Bundled Software for the Server
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows Server 2008)
Chapter 2 Installing Bundled Software
(8) Aborting the Upgrade
If necessary, you can abort the Active Upgrade process and restore the system to its original state at the split
mode or the merge mode of the upgrade process prior to committing the upgrade.
Important
You cannot abort the upgrade process after you commit an upgrade because the
original state of the system is lost (overwritten) as a result of completing the
upgrade process.
When you abort an upgrade, the Active Upgrade Console:
• Cancels the current Active Upgrade operation.
• If your system is in the merge state, shuts down the Upgrade Side and restarts the system from the
Production Side, which automatically restarts your applications from your Production side system disks.
• Reestablishes the mirror of any internal RDR system disk by overwriting the upgraded partner disk with the
original partner disk.
To abort an upgrade, click the Abort button on the Active Upgrade page, the Split System page, or the Merge
System page.
Important
Your screen might flicker and you might briefly lose control of your keyboard and
mouse as the system recovers its original state.
When the process completes, the upgrade state is Fault Tolerant\Abort\Ready. You can click Finish to clean
up ftServer resources, as described in Chapter 2 (1.5.4 (7) Finishing the Upgrade).
If the abort process fails the first time, you can click Retry to try again. If the problem persists, refer to Chapter 1
(8. Troubleshooting) in Maintenance Guide for information about resolving the problem.
To Next Page
Loading...
Need help?
General