1. Bundled Software for the Server
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows Server 2008)
(7) Finishing the Upgrade
To complete the Active Upgrade process and clean up ftServer system resources after committing or aborting
an upgrade, click Finish on the Commit Upgrade page or Abort Upgrade page.
When the process completes, the upgrade state is Fault Tolerant\Idle\Ready.
If the finish process fails the first time, you can click Retry to try again. If the problem persists, refer to Chapter 1
(8. Troubleshooting) in Maintenance Guide for information about resolving the problem.
On the Finish page, upon successful completion of the Active Upgrade process, you can:
• Click Exit to close the Active Upgrade Console.
• Click Save Log to save the activity log to a file.
• Click Active Upgrade in the navigation bar to initiate another readiness test and upgrade with the same
configuration.
• Click Configuration in the navigation bar to create, edit, or load another configuration file.
Important
Though the Active Upgrade process is complete, your RDR disks continue to
resynchronize in the background. If you intend to initiate another upgrade process,
Chapter 1 (8.11 (4) Verifying If RDR Disks Are Resynchronizing) in Maintenance
Guide for more information.
To Next Page
Loading...
Need help?
General