Program
Number
Program Name Description/Comments Assigned Data 1 2 3
10-46-06 DT800/DT700 Server
Information Setup –
Register Port
Port the SIP messages are sent to on
the VoIPU card. This same port num-
ber must be assigned in the SIP Multi-
line terminals.
Changing this command also re-
quires a CPU reset.
Range = 0 ~ 65535
Default is 5080
X
10-46-07 DT800/DT700 Server
Information Setup – En-
cryption Mode
Enable or disable encryption mode. 0 = Off
1 = On
1 = Default
X
10-46-08 DT800/DT700 Server
Information Setup – En-
cryption Type
Assign the encryption type. 0 = Mode 1
Default is 0
READ ONLY
X
10-46-09 DT800/DT700 Server
Information Setup –
One-Time Password
Password used when Program
10-46-07 is set to ON. Assign a char-
acter string of 10 characters or less.
Valid Characters
(0~9, *, #)
Default Not assigned
X
10-46-10 DT800/DT700 Server
Information Setup –
Start Port
With Automatic logon the starting port
number for automatic port allocation.
Range = (1 ~ 128)
Default = 1
X
15-05-01 IP Telephone Terminal
Basic Data Setup – Ter-
minal Type
Type of IP terminal registered with the
specified extension number.
1 = H.323
2 = SIP
3 = None
4 = SIP MLT
Default is 3
READ ONLY
X
15-05-02 IP Telephone Terminal
Basic Data Setup – Ter-
minal MAC Address
Allow association of a MAC Address
to an extension. When the IP phone
sends a register message to the CPU
the CPU responds back with the ex-
tension number associated to the
MAC address.
00.00.00.00.00.00~
FF.FF.FF.FF.FF.FF
Default is
00.00.00.00.00.00
X
15-05-07 IP Telephone Terminal
Basic Data Setup – Us-
ing IP Address
IP address the IP Terminal is using for
the specified extension number.
0.0.0.0~
255.255.255.255.
Default is 0.0.0.0
READ ONLY
X
15-05-15 IP Telephone Terminal
Basic Data Setup –
CODEC Type
Assign CODEC type for IP Terminal. If
SIP SLT, use Program 84-19. If SIP
MLT, use Program 84-24.
1 = Type 1
2 = Type 2
3 = Type 3
4 = Type 4
5 = Type 5
1 = Default is 1
X
15-05-20 IP Telephone Terminal
Basic Data Setup –
Bottom Option Informa-
tion
Read Only CM showing type of adapt-
er installed on the ITH-style tele-
phone.
0 = No Option
1 = ADA
2 = BHA
Default is 0
READ ONLY
X
15-05-26 IP Telephone Terminal
Basic Data Setup –
DT700 Terminal Type
Assign type of SIP MLT terminal con-
nected.
0 = Not Set
1 = Not Used
2 = ITL Series-12/24 But-
ton without 8LK Unit
3 = Not Used
4 = Not Used
5 = Softphone
6 = CTI
7 = Not Used
8 = Not Used
9 = IP4WW-24TIXH
Default is 0
10 ~ 17 = Not Used
18 = IP7WW-8IPLD-C1
X
SL2100 ISSUE 1.0
9-32
IP Multiline Station (SIP)
To Next Page
Loading...
