• An IP Phone (IP Phone and Soft phone) with DSS console cannot be overridden from another IP
Phone.
• The login ID and Password are programmed in Program 15-05-27 and Program 84-22.
• IP Phone Relocation can be used only in Manual Registration Mode.
• Two ports of the same terminal type (Program 15-05-26) cannot be assigned to the same Personal
ID index (Program 15-05-27).
• When using Override with an active CTI connection, Program 15-05-39 must be enabled for the
extensions that will be overridden. The overriding terminal must be of the same type and number of
line keys as the terminal to be overridden. If the types of terminals and number of keys are different
between overriding and overridden phones, the Telephony Service Providers (1st Party and 3rd
Party) may not function properly.
Table 9-4 IP Phone Relocation
Program/Item
No.
Description/
Selection
Assigned Data Comments
10-46-01 DT800/DT700 Server Informa-
tion Setup – Register Mode
0 = Plug and Play
1 = Automatic
2 = Manual
Default is 0
Set up the information of the SIP Multiline
(8IPLD series) Server.
This Program is a system-wide setting.
15-05-27 IP Telephone Terminal Basic
Data Setup – Personal ID In-
dex
0~128
0
Default is 0
Used when the SIP Multiline telephone is
using manual/
auto registration. Assign each phone a
unique personal index. Then go to com-
mand 84-22 to assign the user name and
password.
84-22-01 DT800/DT700 Multiline Logon
Information Setup – User ID
Up to 32 characters
Default not assigned
Input the User ID when using manual or
auto registration (Program 10-46-01).
84-22-02 DT800/DT700 Multiline Logon
Information Setup – Password
Up to 16 characters
Default not assigned
Input the Password when using manual or
auto registration (Program 10-46-01).
84-22-04 DT800/DT700 Multiline Logon
Information Setup – Log Off
0 = Off
1 = On
Default is 1
Input the Personal ID from terminal auto-
matically when log on again.
If set to 0, IP Phone Relocation fails.
ISSUE 1.0 SL2100
Networking Manual 9-45
To Next Page
Loading...
