NEC SL2100 - Section 3 HOW to ENTER PROGRAMMING MODE

tells you to enter the programming mode, dial 150701 from the telephone dial pad. After you do, you
will see the message “15-07-01 TEL” on the first line of the telephone display. This indicates the
program number (15-07), item number (01), and that the options are being set for the extension. The
second row of the display “KY01 =
*
01” indicates that Key 01 is being programmed with the entry of
*
01. The third row allows you to move the cursor to the left or right, depending on which arrow is
pressed. To learn how to enter the programming mode, refer to How to Enter Programming Mode on
page 5-2.
SECTION 3 HOW TO ENTER PROGRAMMING MODE
To enter programming mode :
1. Go to any working display telephone.
In a newly installed system, use extension (port 1).
2. Do not lift the handset.
3. Press Speaker.
4. #
*
#
*
.
5. Dial the system password + Hold.
Refer to the following table for the default system passwords. To change the passwords, use
90-02 : Programming Password Setup.
Program Mode
Hybrid (4W) Multiline Terminal
Program Mode
Base Service OP1 OP2
IP Multiline Terminal
Password User Name Level Programs at this Level
12345678 tech 2 (IN) Installation (IN) :
IN, SA and SB levels defined by 90-26 are available.
0000 admin1 3 (SA) System Administrator - Level 1 (SA) :
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17, 10-18, 10-23,
10-25, 10-28, 10-29, 10-45, 10-67, 10-74, 12-02, 12-03, 12-04, 12-08,
15-01, 15-07, 15-09, 15-10, 15-11, 15-20, 20-16, 20-34, 20-57, 20-63,
20-64, 20-66, 20-70, 21-07, 21-14, 22-04, 22-11, 22-17, 25-08, 30-03, ,
32-02, 41-02, 41-03, 41-04, 41-05, 41-06, 41-07, 41-08, 41-09, 41-11,
41-12, 41-13, 41-14, 41-16, 41-17, 41-18, 41-19, 41-20, 45-02, 84-16,
84-22, 90-03, 90-04, 90-06, 90-07, 90-16, 90-19, 90-65, 93-01, 93-02,
93-03, 93-04, 93-05, 93-06
9999 admin2 4 (SB) System Administrator - Level 2 (SB) :
13-04, 13-05, 13-06, 13-11, 15-14, 21-20
SL2100 ISSUE 1.0
5-2
PROGRAMMING