EasyManua.ls Logo

NEC SL2100 - Section 5 ASPIRENET EXAMPLE

NEC SL2100
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SECTION 5 ASPIRENET EXAMPLE
The examples in this section are only a guide to the configuration required on the SL2100 to install
AspireNet Operation.
5.1 AspireNet - IP
5.1.1 VoIP Networking Example
AspireNet IP requires the VOIPDB Blade and SL2100 Networking License. The VOIPDB Blade
provides the speech resources.
The example below shows two SL2100 systems, each has a VOIPDB Blade installed. The VOIPDB
Blades are connected to a hub via a standard LAN patch cable. SL2100 A has extension numbers in
the range 200-299, SL2100 B has 300-399.
SL2100 A
Hub
VOIPDBVOIPDB
SL2100 B
SL2100 A SL2100 B
Program 10-12-09
IP Address of the VOIPDB = 172.16.0.10
Program 10-12-10
Subnet Mask = 255.255.0.0
Program 10-12-09
IP Address of the VOIPDB = 172.16.5.10
Program 10-12-10
Subnet Mask = 255.255.0.0
Program 10-19-01
DSP Resource is assigned for the Network.
= 3
Program 10-19-01
DSP Resource is assigned for the Network.
= 3
Program 10-20-01
TCP Port Setup Device 4 = 30000
Program 10-20-01
TCP Port Setup Device 4 = 30000
Program 10-27-01
Destination IP Address and port number for each ID
ID 1 = IP Address 172.16.5.10
Procedure port must be set to 1730
Program 10-27-01
Destination IP Address and port number for each ID
ID 1 = IP Address 172.16.0.10
Procedure port must be set to 1730
Program 11-01-01
System Numbering
Dial 2x = 3 digit, Type 2 (Intercom)
Dial 3x = 3 digit, Type 8 (Networking), ID = 1
Program 11-01-01
System Numbering
Dial 2x = 3 digit, Type 8 (Networking), ID=1
Dial 3x = 3 digit, Type 2 (Intercom)
Program 84-02-35
Enable Fast Start
Program 84-02-35
Enable Fast Start
Program 84-34-01 (Type = 2, Profile = 1)
DTMF Relay Mode 1 = RFC2833
Program 84-34-01 (Type = 2, Profile = 1)
DTMF Relay Mode 1 = RFC2833
Program 84-26-01
IP address for each DSP
172.16.0.20
Program 84-26-01
IP address for each DSP
172.16.5.20
Explanation of routing for IP AspireNet
When a user places a call to a remote extension number the dialed digits are checked against the
Numbering Scheme in Program 11-01. This will provide the Node ID number of the route to the remote
SL2100
ISSUE 1.0
13-30
AspireNet

Table of Contents

Other manuals for NEC SL2100

Related product manuals