When you want to ... Telephone Programming
Change Program Number Soft Key3
Change Index Number
Move Cursor to Right Cursor Key (Right)
Soft Key4
SECTION 6 PROGRAMMING NAMES AND TEXT MESSAGES
Several programs (e.g., Program 20-16 : Selectable Display Messages) require you to enter text. Use
the following chart when entering and editing text. When using the keypad digits, press the key once
for the first character, twice for the second character, etc. For example, to enter a C, press the key 2
three times. Press the key six times to display the lower case letter. The name can be up to 12 digits
long.
Table 5-3 Keys for Entering Names
Use this keypad digit ... When you want to ...
1 Enter characters : 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 0
2 Enter characters : A-C, a-c, 2.
3 Enter characters : D-F, d-f, 3.
4 Enter characters : G-I, g-i, 4.
5 Enter characters : J-L, j-l, 5.
6 Enter characters : M-O, m-o, 6.
7 Enter characters : P-S, p-s, 7.
8 Enter characters : T-V, t-v, 8.
9 Enter characters : W-Z, w-z, 9.
0 Enter characters : 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed - ex : TOM).
Pressing # again = Space. (In system programming mode, use the right arrow Softkey in-
stead to accept and/or add a space.)
Clear/Back or DND/CONF (4W
Hybrid Multiline Terminal) / DND
(IP Multiline Terminal)
Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
SECTION 7 USING SOFTKEYS FOR PROGRAMMING
(This Feature is available for IP Multiline Terminal Only.)
Each Display telephone with Softkeys provides interactive Softkeys for intuitive feature access. The
options for these keys will automatically change depending on where you are in the system
programming. Simply press the Softkey located below the option you wish and the display will change
accordingly.
ISSUE 1.0
SL2100
Networking Manual 5-5
To Next Page
Loading...
