Network Settings
• DHCP Mode - DHCP Disable. Click OK.
• IP Address - Enter the IP Address for the station, and click OK.
• Default Gateway - Enter the Default Gateway Address, and click OK. If you are testing without a
router/gateway, this must be left at the default 0.0.0.0.
• Subnet Mask - Enter the Subnet Mask for the station, and click OK.
SIP Settings
• SIP User
- User ID - Enter User ID assigned in command 84-22. Click OK.
- Password - Enter the password assigned in command 84-22. Click OK.
- Incom Number - Enter the extension number for the IP station. Click OK.
•
Server Address & URI - 1
st
Server Address
Enter the IP address assigned in command 10-12-09, and click OK.
•
SIP Server Port - 1
st
Server Port
Enter port 5080. Click OK.
• Press the EXIT key until you are back at the Main menu.
• Press the SAVE key, and the phone saves the configuration to memory, reboots itself and registers
with the CPU.
13.10.3 Manual Registration
Steps 1~4 are the same as for Section Automatic Registration on page 9-41.
1. Same as for Automatic Registration Mode.
2. Same as for Automatic Registration Mode.
3. Same as for Automatic Registration Mode.
4. Same as for Automatic Registration Mode.
5. Program10-46 – ChangeProgram10-46-01 to Manual.
Figure 9-35 8IPLD Server Information Setup
6. Same as for Automatic Registration Mode.
7. Same as for Automatic Registration Mode.
ISSUE 1.0
SL2100
Networking Manual 9-43
To Next Page
Loading...
