NEC SL2100 - Page 86

IP7WW-VoIPDB-C1
SL2100 IP CHANNEL-16 LIC
SL2100 IP TRUNK-01 LIC
7.3 Programming
Program
Number
Program Name/Description Input Data Assigned Data Level
1 2 3
10-02-01 Location Setup – Country Code
Enter the country code.
Dial (maximum of four digits)
0 ~ 9,
*
, #
1 ✓
10-02-02 Location Setup – International Ac-
cess Codes
Enter the international access
code.
Dial (maximum of four digits)
0 ~ 9,
*
, #
No Setting ✓
44-01-02 System Options for ARS/F-Route
– Dial Tone Simulation
Dial digits to be analyzed by the
system. Numbering plan for the di-
al needs to be configured as F-
Route in Program 11-01.
Dial (maximum of one digit)
0 ~ 9,
*
, # cannot be used Profile
(1 ~ 6)
No Setting ✓
44-01-03 System Options for ARS/F-Route
– Tone Type
Set simulated DT to type which
can change the tone used in Pro-
gram 44-01-02 and Program
44-02-04.
0 = Internal Dial Tone
1 = External Dial Tone
0 ✓
84-14-13 SIP Trunk Basic Information Setup
– Incoming/ Outgoing SIP Trunk
for E.164
When this data is set to 1, then for
any outbound SIP calls a + is add-
ed as a prefix to the Request-URI,
To and From header fields of the
SIP message.
When it is set to 2 then if the di-
aled international access code
matches the value in Program
10-02-02 this value is removed
from the number dialed and the +
added as a prefix to the Request-
URI, To and From header fields of
the SIP Message.
0 = Off
1 = Mode 1
2 = Mode 2
3 = Mode 3
Profile (1 ~ 6)
0 ✓
7.4 Operation
7.4.1 To Transfer a Call into a Conference:
1. While on a call, press Hold key.
2. Dial the Transfer to Conference service code (PRG 11-12-58, default = 884).
If the telephone does not have the proper COS, a warning tone is sent. After the user hangs up, the
system automatically places a Callback to the extension.
The display shows the line Number, Number/Name and Extension Name/Number.
SL2100 ISSUE 1.0
7-18
SIP Trunking