Chapter 7: Troubleshooting | 111
N300 Wireless Gigabit ADSL2+ Modem Router DGN3500 User Manual
Restoring the Default Configuration and Password
This section explains how to restore the factory default configuration settings, changing the
router’s administration password to password and the IP address to 192.168.0.1. You can
erase the current configuration and restore factory defaults in two ways:
• Use th
e Erase function of the Web Configuration Manager (see Erasing the
Configuration on
page 61).
• The
DGN3500 has a dedicated reset button located on the back panel. Press reset button
for over 5 seconds. The LED will blink and the router will reboot. The factory default
setting is restored after system boots up.
Using the Wireless On/Off and WPS Buttons to Reset the
Router
To restore the factory default configuration settings when you do not know the administration
password or IP address, you must use the Wireless On/Off and WPS buttons on the side
panel of the router:
1. Pre
ss and hold the Wireless On/Off and WPS buttons simultaneously until the Power
LED turns red (about 6 seconds).
2. T
he DGN3500 has a dedicated reset button located on the back panel. Press reset
button for over 5 seconds. The LED will blink and the router will reboot. The factory
default setting is restored after system boots up.
To Next Page
Loading...
Need help?
General
