48 | Chapter 3: Protecting Your Network
N300 Wireless Gigabit ADSL2+ Modem Router DGN3500 User Manual
time, and clear it at the end. Enabling daylight savings time causes
one hour to be added to the standard time.
4. The wireless modem router has a list of NETGEAR NTP servers. If you would prefer to use
a particular NTP server as the primary server, select the Use this NTP Server check box,
and enter its IP address.
5. Click Apply to save
your settings.
Scheduling Firewall Services
If you enabled services blocking in the Block Services screen or port forwarding in the Ports
screen, you can set up a schedule for when blocking occurs or when access is not restricted.
1. Log in to the wir
eless modem router at its default LAN address of http://192.168.0.1
with its default user name of admin and default password of password, or using
whatever password and LAN address you have chosen for the wireless modem router.
2. Select Sched
ule below Security to display the Schedule screen that is shown in Figure 24.
3. T
o block Internet services based on a schedule, select Every Day or select one or more
days. If you want to limit access completely for the selected days, select All Day. Otherwise,
to limit access during certain times for the selected days, or enter times in the Start Time
and End Time fields.
Note: Enter the values in 24-hour time format. For example, 10:30 a.m.
would be 10
hours and 30 minutes, and 10:30 p.m. would be 22
hours and 30 minutes. If you set the start time after the end time, the
schedule will be effective through midnight the next day.
4. Click Apply to save your changes.
To Next Page
Loading...
Need help?
General
