Appendix A: Technical Specifications
N300 Wireless Gigabit ADSL2+ Modem Router DGN3500 User Manual
Factory Default Configuration
You can use the Restore Factory Settings button on the rear panel of the wireless modem
router to return its configuration to the factory settings. This is called a hard reset. To perform
a hard reset, press and hold the Restore Factory Settings button until the LEDs flash. Your
wireless modem router restarts and returns to the factory configuration settings shown in the
following table.
Feature Default Behavior
Login
Modem Router user login URL http://www.routerlongin.com
User name
(case-sensitive) admin
Login password (case-sensitive) password
ReadyShare Access \\readyshare
Internet Connection
WAN MAC address Use default address
W
AN MTU size 1500
Port speed Autosensing
Local Network (LAN)
LAN IP 192.168.0.1
Sub
net mask 255.255.255.0
RIP direction None
RIP version Disabled
RIP authentication None
DHCP server Enabled
DHCP starting IP address 192.168.0.2
To Next Page
Loading...
Need help?
General
