GS108T Smart Switch Software Administration Manual
6-10 Monitoring, Maintenance, and Help
v1.0, December 2007
2. Under Logs Configuration, the following fields are displayed. All fields are configurable:
• Logging. Specifies whether RAM and flash logging is enabled on the device. Select one
of the following radio buttons:
– Enable. Specifies that RAM and flash logging is enabled.
– Disable. Specifies that RAM and flash logging is disabled.
• RAM. Select the check box to set the severity levels for RAM.
• Flash. Select the check box to set the severity levels for RAM.
• Emergency. Specifies whether emergency messages are logged. Select one of the
following values from the drop-down list:
– On. Specifies that emergency messages are logged.
– Off. Specifies that emergency messages are not logged.
• Alert. Specifies whether alerts are logged. Select one of the following values from the
drop-down list:
– On. Specifies that alerts are logged.
– Off. Specifies that alerts are not logged.
• Critical. Specifies whether critical messages are logged. Select one of the following
values from the drop-down list:
– On. Specifies that critical messages are logged.
– Off. Specifies that critical messages are not logged.
• Error. Specifies whether error messages are logged. Select one of the following values
from the drop-down list:
– On. Specifies that error messages are logged.
– Off. Specifies that error messages are not logged.
• Warning. Specifies whether warnings are logged. Select one of the following values from
the drop-down list:
– On. Specifies that warnings are logged.
– Off. Specifies that warnings are not logged.
• Notice. Specifies whether notifications are logged. Select one of the following values
from the drop-down list:
– On. Specifies that notifications are logged.
– Off. Specifies that notifications are not logged.
To Next Page
Loading...
