GS108T Smart Switch Software Administration Manual
4-8 Configuring Switching
v1.0, December 2007
2. You can make changes to the LACP port priority settings for an individual port, for a group of
ports, or for all ports simultaneously:
• To change the LACP port priority settings for an individual port, select the check box to
the left of its port number, and then select the LACP port priority settings.
• To change the LACP port priority settings for a group of ports, select the check boxes to
the left of their port numbers, and then select the LACP port priority settings.
• To change the LACP port priority settings for all ports simultaneously, select the check
box at the top of the column of check boxes, and then select the LACP port priority
settings.
The following information about the LACP priority for a port is displayed. Both the LACP
Priority and Timeout fields are configurable.
• Port. Shows the port number.
• LACP Priority. Specifies the port priority value in a range from 1 to 65335.
Figure 4-6
Note: You can also enter the interface number (that is, the port number) in the GO
TO INTERFACE field, and then click GO.
To Next Page
Loading...
