GS108T Smart Switch Software Administration Manual
Configuring QoS and Security 5-3
v1.0, December 2007
.
2. You can make changes to the bandwidth limits for an individual port, for a group of ports, or
for all ports simultaneously:
• To change the bandwidth limits for an individual port, select the check box to the left of its
port number, and then select bandwidth limits.
• To change the bandwidth limits for a group of ports, select the check boxes to the left of
their port numbers, and then select the bandwidth limits.
• To change the bandwidth limits for all ports simultaneously, select the check box at the top
of the column of check boxes, and then select the bandwidth limits.
The following port configuration information is displayed. All fields are configurable:
• Port. Specifies the port number.
• Ingress Rate. Specifies the rate limitation of incoming traffic in this port. The possible
values in bits per second (bps) are:
– 512K bps, 2M bps, 4M bbps, 10M bps, 20M bps, 40M bps, 60M bps, 100M bps,
200M
bps, 400M bps, and 1000M bps.
Figure 5-2
Note: You can also enter the interface number (that is, the port number) in the GO
TO INTERFACE field, and then click GO.
To Next Page
Loading...
