GS108T Smart Switch Software Administration Manual
Configuring QoS and Security 5-11
v1.0, December 2007
.
2. Under 802.1x Configuration, the following fields are displayed, all of which are configurable:
• Port Based Authentication State. Specifies whether port authentication is enabled on the
device. Select one of the following radio buttons:
– Disable. Specifies that port-based authentication is disabled.
– Enable. Specifies that port-based authentication is enabled.
• Authentication Method. Specifies the authentication method that is used for port
authentication. Port authentication must be enabled to select an authentication method
from the drop-down list. The possible field values are:
– RADIUS, None. Specifies that port authentication occurs through the RADIUS
server. However, if the port is not authenticated, then no authentication method is
used, and the session is permitted.
Figure 5-8
To Next Page
Loading...
