86 | Chapter 6. Advanced Settings
NETGEAR N300 Wireless Router JWNR2000v2 User Manual
2. Log in to the router that will be the repeater. Check the Wireless Settings screen, and verify
that the wireless settings match the base station exactly. If the settings are different, be sure
to configure the wireless settings to match the base station settings (see
Wireless Settings
on page 33).
3. In the Wireless Repeating Function screen, select the Enable Wireless Repeating
Function check box and the Wireless Repeater radio button.
4. Fill in the IP Address field. This IP address must be in the same subnet as the base station,
but different from the LAN IP of the base station.
5. Fill in the Base Station MAC Address field.
6. Click Apply to save your changes.
7. Verify connectivity across the LANs.
A computer on any wireless or wired LAN segment of the router should be able to
connect to the Internet or share files and printers with any other wireless or wired
computer or server connected to the other access point.
To Next Page
Loading...
Need help?
General
