Advanced Settings
108
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700v2
To set up port triggering, you need to know which inbound ports the application needs. Also,
you need to know the number of the outbound port that will trigger the opening of the inbound
ports. You can usually determine this information by contacting the publisher of the
application or user groups or newsgroups.
To set up port triggering:
1. Select Advanced > Ad
vanced Setup > Port Forwarding/Port Triggering.
2. Select the Port
Triggering radio button to display the port triggering information.
3. Clear the Disable Port Triggering check box if it is selected.
Note: If the Disable Port Triggering check box is selected
after you configure
port triggering, port triggering is disabled. However, any port triggering
configuration information you added to the wireless modem router is retained
even though it is not used.
4. In
the Port Triggering Timeout field, enter a value up to 9999 minutes.
This va
lue controls the inactivity timer for the designated inbound ports. The inbound
ports
close when the inactivity time expires. This is required because the wireless modem
router cannot be sure when the application has terminated.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
