Advanced Settings
112
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700v2
To set up a static route:
1. Select Advanced > Advanced Setup > Static Routes, and click Add to display the
following screen:
2. In the Route Name field, type a name for this static route (for identification purposes only.
3. Select the Privat
e check box if you want to limit access to the LAN only. If Private is
selected, the static route is not reported in RIP.
4. Select the Active check box to make this route ef
fective.
5. Type the IP address of the final destination.
6.
Type the IP subnet mask for this destination. If the destination is a single host, type
255
.255.255.255.
7. Type the gateway IP address, which has to be a wireless modem router on the same LAN
segmen
t as the N600 Modem Router.
8. Type a number between 1 and 15 as the metric value.
This va
lue represents the number of wireless modem router
s between your network and
the destination. Usually, a setting of 2 or 3 works, but if this is a direct connection, set it to
1.
9. Click Apply to ad
d the static route.
To Next Page
Loading...
