Name: NETGEAR Nighthawk AC1900 D7000v2
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

To reset the modem router to factory default settings:

1. On the back of the modem router, locate the Reset button.

2. Using a straightened paper clip, press and hold the Reset button for at least five seconds.

3. Release the Reset button.

The Power LED starts blinking amber and the configuration is reset to factory default settings. When

the reset is complete, the modem router reboots.This process takes about two minutes.

WARNING:

To avoid the risk of corrupting the firmware, do not interrupt the reset. For

example, if you are connected to the modem router’s web page, do not close

the browser, click a link, or load a new page. Do not turn off the modem router.

Wait until the modem router finishes restarting and the Power LED turns solid

white.

Erase the Settings

CAUTION:

This process erases all settings that you configured in the modem router.

Manage the Modem Router and Monitor the Traffic

160

Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000v2

Questions and Answers:

Need help?

Do you have a question about the NETGEAR Nighthawk AC1900 D7000v2 and is the answer not in the manual?

NETGEAR Nighthawk AC1900 D7000v2 Specifications

General