(Continued)
DescriptionField
The modem router captures and uses the MAC address of the computer that
you are now using.You must use the one computer that is registered by the
ISP.
Use Computer MAC Address
Enter the MAC address that you want to use. By default, the field displays
the MAC address of the Internet port.
Use This MAC Address
11. Click the Apply button.
Your settings are saved.
12. Click the Test button to test your Internet connection.
If the NETGEAR website does not display within one minute, see Troubleshoot the Internet Connection
on page 203.
Specify an IPv6 Internet Connection
If you want to use an IPv6 Internet connection, you must specify the settings manually. NETGEAR genie
and the Setup Wizard do not detect an IPv6 Internet connection automatically.
IPv6 Internet Connections and IPv6 Addresses
The modem router can support an IPv6 Internet connection through the following connection types:
• Auto Detect. For more information, see Set Up an IPv6 Connection Through Auto Detect on page 56.
• 6to4 tunnel. For more information, see Set Up an IPv6 6to4 Tunnel Connection on page 57.
• Pass-through. For more information, see Set Up an IPv6 Fixed Connection on page 60.
• Fixed. For more information, see Set Up an IPv6 Fixed Connection on page 60.
• DHCP. For more information, see Set Up an IPv6 DHCP Connection on page 64.
• PPP over Ethernet. For more information, see Set Up an IPv6 PPPoE Connection on page 65.
• Auto Config. For more information, see Set Up an IPv6 Connection Through Auto Config on page 67.
• 6rd Tunnel. For more information, see Set Up an IPv6 6rd Tunnel Internet Connection on page 68.
Which connection type you must use depends on your IPv6 ISP. Follow the directions that your IPv6 ISP
gave you.
Manage the Internet Settings Manually
55
Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000v2
To Next Page
Loading...
Need help?
General
