NETGEAR ProSafe GSM7224

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
IS CLI Mapping A-1
202-10009-01_060204
Appendix A
IS CLI Mapping
This chapter illustrates the mapping between CLI commands and the previous 7200 Series L2
Switch commands. The Package column indicates the 7200 Series L2 Switch package in which the
command is located.
Table 9-1. IS CLI Mapping
Package 7200 Series L2 Switch Command
CLI Command
Mode Syntax
Switching show serviceport Privileged
EXEC
show serviceport
Switching show snmpcommunity Privileged
EXEC
show snmpcommunity
Switching show snmptrap Privileged
EXEC
show snmptrap
Switching show trapflags Privileged
EXEC
show trapflags
Switching show telnet Privileged
EXEC and
User
EXEC
show remotecon
Switching show forwardingdb agetime [fdbid |
all]
Privileged
EXEC
show forwardingdb agetime {<fdbid> |
all}
Switching config network parms <ipaddr>
<netmask> [gateway]
Privileged
EXEC
network parms <ipaddr> <netmask>
[<gateway>]
Switching config network protocol <none |
bootp | dhcp>
Privileged
EXEC
network protocol {none | bootp |
dhcp}
Switching config network webmode <enable |
disable>
Privileged
EXEC
ip http server