Configure System Information
41
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
The default password is password.
The System Information page displays.
5. Select System > Management > Time > SNTP Server Configuration.
6. From the Server Type menu, select the type of SNTP address to enter in the Address field.
The address can be either an IP address (IPv4, IPv6) or a host name (DNS). The default
value is IPv4.
7. In the Address field, specify the IP address or the host name of the SNTP server.
Unicast SNTP requests are sent to this address. If this address is a DNS host name, then
that host name is resolved into an IP address each time an SNTP request is sent to it.
8. If the UDP port on the SNTP server to which SNTP requests are sent is not the standard
port (123), specify the port number in the Port field.
The valid range is 1 to 65535. The default value is 123.
9. Click the Add button.
The SNTP server entry is added. This sends the updated configuration to the switch.
Configuration changes take effect immediately.
10. Repeat the previous steps to add additional SNTP servers.
You can configure up to eight SNTP servers.
The SNTP Server Status table displays status information about the SNTP servers
configured on your switch. The following table describes the SNTP Server Global Status
information.
Table 7. SNTP Server Status information
Field Description
Address All the existing server addresses. If no server configuration exists, a message stating
that no SNTP server exists displays on the page.
Last Update Time The local date and time (UTC) that the response from this server was used to update
the system clock.
To Next Page
Loading...
Need help?
General
