8. Press the ‘Add’ button and in the “Service Settings” window:
i. Enter Video TCP in the ‘Description of service’ field.
ii. Enter 192.168.199.228 in the ‘Name or IP address’ field.
iii. Enter 3659 in the ‘External Port number for this service’ field.
iv. Enter 3659 in the ‘Internal Port number for this service’ field.
v. Select the TCP radio button.
vi. Press ‘OK’.
Press the ‘Add’ button and in the Service Settings window:
1. Description of service: Enter Video UDP
2. Name or IP address’: Enter 192.168.199.228
3. External Port number for this service: Enter 2649
4. Internal Port number for this service: Enter 2649
5. Select the UDP radio button.
6. Press ‘OK’.
a) Press OK in the Advanced Settings window.
b) Press OK in the Windows Firewall window.
c) Press ‘Close’ in the Local Area Connection Properties window.
d) Install VCS2 on the Service PC.
e) Run VCS2 on the service PC.
10.9 Configuration
The required video capture interval is 15 seconds (4 images per minute) for each video source.
The Core Module initiates the capture of video information and specifies its configuration. This
includes:
▪ the video channel to be digitized.
▪ the sources of the vertical and horizontal syncs.
▪ the coefficients for the Phase Locked Loop (PLL) -generated pixel clock (or selection of
an external clock); and
▪ the dimensions (number of samples and lines) of the captured frame.
The video capture can be configured using the Video Configuration suite.
▪ Edit the <VidChanX.ini> file for each video source.
To Next Page
Loading...
