11
English
X-COM2
You can charge the X-COM2 by connecting the supplied USB power
& data cable into a computer’s USB port or USB wall charger. You can
use any standard micro-USB cable to charge the X-COM2. The LED
turns red while the headset is charging and turns blue when it is fully
charged. It takes about 2.5 hours to be completely charged.
Note:
• The X-COM2 is compatible with 5 V input USB-charged devices only.
• Any 3rd party USB charger can be used with Nexx products if the
charger is approved by either the FCC, CE, IC or other locally approved
agencies that Nexx accepts.
CAUTION
Please make sure to take off your X-COM2-installed helmet while
charging. The headset automatically turns off during charging.
4.4 Low Battery Warning
When the battery is low, the blinking blue LED in stand-by mode turns
to red and you will hear a voice prompt saying “Low Battery”.
4.5 Checking the Battery Level
You can check the battery level in two different ways when the headset
is powering on.
4.5.1 LED Indicator
When the headset is powering on, the red LED ashes rapidly
indicating the battery level.
4ashes=High,70~100%
3ashes=Medium,30~70%
2ashes=Low,0~30%
Note:
1. The battery performance may be reduced over time with usage.
2. Battery life may vary depending on conditions, environmental factors,
functions of the product in use, and devices used with it.
4.5.2 Voice Prompt Indicator
When you power on the headset, press and hold the Center Button
and the (+) Button for more than 6 seconds until you hear three, high-
toned beeps. Then you will hear voice prompt indicating the battery
level. However, if you release the buttons as soon as the headset turns
on, you will not hear the voice prompt of battery level indication.
To Next Page
Loading...
