Nexx X-COM2 - Configuration Setting; Phone Pairing; Second Mobile Phone Pairing; GPS Pairing

42
X-COM2
23 CONFIGURATION SETTING
You can set the conguration of the X-COM2 by the voice menu
instruction as below.
1. Toenter into voicecongurationmenu,presstheCenter Button
for 12 seconds until you hear high-toned double beeps. You will
also hear a voice prompt saying “Conguration menu”.
2. Tap the (+) Button or the (-) Button to navigate between the
menus. You will hear voice prompts for each menu item as below.
3. You can enable the feature or execute the command by tapping
the Center Button, or disable the feature by tapping the Center
Button.
4. If any button is not pressed within 10 seconds, the X-COM2 will
exitthecongurationandgobacktostand-by.
5. Ifyouwanttoexitthecongurationimmediately,tapthe(-)Button
and you will hear a voice prompt, “Exit conguration”, and tap
the Center Button.
The voice prompt for each menu item is as below:
(1) Phone pairing (6) Delete all pairings
(2) Second mobile phone pairing (7) Remote control pairing
(3) GPS pairing (8) Universal intercom pairing
(4) Phone selective pairing (9) Factory reset
(5) Media selective pairing (10) Exit conguration
(-) Button
or
(+) Button
Tap
Phone pairing
Second mobile phone pairing
GPS pairing
Phone selective pairing
Media selective pairing
Delete all pairings
Remote control pairing
Universal intercom pairing
Factory reset
Exit configuration