46
X-COM2
24 RESET TO FACTORY DEFAULT SETTINGS
1. To restore the X-COM2 to factory default settings, press the Center
Button for 12 seconds until you hear high-toned double beeps.
You will hear a voice prompt saying “Conguration menu”.
2. Tap the (-) Button twice and you will hear a voice prompt saying
“Factory reset”.
3. Within 5 seconds, tap the Center Button to conrm reset. The
headset will be restored to factory setting and switched off
automatically. You will hear a voice prompt saying “Headset
reset, good-bye”.
25 FAULT RESET
When the X-COM2 is not working properly or is in faulty status for any
reason, you may reset by pushing the pin-hole reset button located
next to the DC Power Charging & Firmware Upgrade Port. Insert a
paper clip into the reset pin-hole and press the reset button for a
second with light pressure. The X-COM2 will be switched off, and you
have to turn on the system back on and try again. However, this will not
restore the headset to factory default settings.
Battery Module
To Next Page
Loading...
