48
X-COM2
CERTIFICATION AND SAFETY APPROVALS
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
a Class B digital device pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment on and
off, the user is encouraged to try to correct the interference by one or
more of the following measures:
•Reorient or relocate the receiving antennae
•Increase the separation between the equipment and the receiver
Type Operation Button Command LED Beep
Music
Play/Pause music
Press the Center Button for
1 second
- -
Track forward
Press the (+) Button for
1 second
- -
Track backward
Press the (-) Button for
1 second
- -
FM Radio
FM radio on/off
Press the (-) Button for
1 second
-
Mid-toned
double beeps
Seek forward Double tap the (+) Button -
High-toned
triple beeps
Seek backward Double tap the (-) Button -
High-toned
triple beeps
Intercom
Intercom pairing
Center Button for 8 seconds
Red
ashing
-
Tap the Center Button -
Start/End intercom Tap the Center Button - -
End all intercoms
Press the Center Button for
5 seconds
Blue
ashing
-
Start group intercom
Tap the (+) Button and the
(-) Button
Green
ashing
-
End group intercom
Tap the (+) Button and the
(-) Button
- -
To Next Page
Loading...
