Nexx X-COM2 - Scan and Save; Temporary Preset; Region Selection

25
English
X-COM2
11.4 Scan and Save
"Scan" is the function that automatically searches station frequencies,
starting from the current frequency and up. To use the scan function,
please follow the procedures below:
1. Press and hold the (+) Button for 1 second. Then the current
stationfrequencymovesupwardtondotherstationfrequencies.
2. Ifthetunerndsastation,itstaysatthestationfrequencyfor8
seconds, then searches the next station frequency.
3. Scan function stops when you press and hold the (+) Button for
1 second.
4. To save a station while scanning frequencies, tap the Center
Button when at that station. You will hear a voice prompt saying
“Save preset (#)”. The station will be saved as the next preset
number.
5. All stations preset during “Scan” will overwrite previously set
stations.
11.5 Temporary Preset
With the temporary preset function, you may temporarily preset
stations automatically without changing the existing preset stations.
Tap the (+) Button three times to automatically scan for 10 temporary
preset stations. The temporary preset stations will be cleared when the
system is powered off.
11.6 Region Selection
You can select the proper FM frequency region from the Device
Manager. With the region setting, you may optimize the seek function
to avoid unnecessary frequency ranges.
Region Frequency range Step
Worldwide 76.0~108.0MHz ± 100 kHz
Americas 87.5~107.9MHz ± 200 kHz
Asia 87.5~108.0MHz ± 100 kHz
Australia 87.5~107.9MHz ± 200 kHz
Europe 87.5~108.0MHz ± 100 kHz
Japan 76.0~95.0MHz ± 100 kHz