Nexx X-COM2 - RDS AF Setting (Default: Disable); FM Station Guide (Default: Enable); Voice Command

26
X-COM2
11.7 RDS AF Setting (Default: Disable)
You can enable or disable RDS AF setting through the Device Manager
or the Smartphone App. RDS AF allows a receiver to re-tune to the
secondfrequencylocation when the rstsignal becomes tooweak.
With RDS AF enabled on the receiver, a radio station with more than
one frequency can be used.
11.8 FM Station Guide (Default: Enable)
You can enable or disable FM Station Guide through the Device
Manager or the Smartphone App. When FM Station Guide is enabled,
FM station frequencies are given by voice prompts as you select
preset stations. When FM Station Guide is disabled, the voice prompts
on FM station frequencies will not be given as you select preset
stations.
12 VOICE COMMAND
The voice command of the X-COM2 allows you to operate certain
operations by simply using your voice. You can control the X-COM2
completely handsfree using the voice recognition. The voice command
function works only with English commands.
Voice Command Procedure:
1. There are two ways to enter the voice command mode. The
simplest way is to tap the Center Button and the (-) Button
simultaneously. Another way is to say, “Hello Sena” during stand-
by mode.
2. Speak a voice command from the table below: