Nexx X-COM2 - Pairing the X-COM2 with Bluetooth Devices; Mobile Phone Pairing

13
English
X-COM2
5 PAIRING THE X-COM2 WITH BLUETOOTH
DEVICES
Before using the X-COM2 Bluetooth headset with any other Bluetooth
devicesforthersttime,youwillneedtopairthemtogether.Itcanbe
paired with Bluetooth mobile phones, Bluetooth stereo devices such
asMP3players,ormotorcyclespecicBluetoothGPSnavigation,and
with other Sena Bluetooth headsets. This pairing operation is only
required once for each Bluetooth device. The headset remains paired
with the devices and automatically reconnects to them when they are
within range. You will hear high-toned double beeps and a voice
prompt when the headset connects to the paired device automatically:
“Phone connected” to a mobile phone, “Media connected” to a
Bluetooth stereo device.
5.1 Mobile Phone Pairing
1. Turn on the X-COM2 and press the Center Button for 12 seconds
until you hear high-toned double beeps. You will hear a voice
prompt saying “Conguration menu”.
2. Within2seconds,tapthe(+)ButtonuntiltheLEDashesredand
blue alternately and you hear multiple beeps. You will hear a voice
prompt saying “Phone pairing”.
3. Search for Bluetooth devices on your mobile phone. Select the
X-COM2 in the list of the devices detected on the mobile phone.
4. Enter 0000 for the PIN. Some mobile phones may not ask for the
PIN.
5. Themobilephoneconrmsthatpairinghasbeencompletedand
the X-COM2 is ready to use. You will hear a voice prompt from the
X-COM2 saying “Your headset is paired”.
6. If the pairing process is not completed within three minutes, the
X-COM2 will return to stand-by mode.