NF DF 1906 - Page 64

5.3 Explanation of Commands
DF1906
5-14
・:SYSTem:PON[:OUTPut] {POFF|PON|LAST}
:SYSTem:PON[:OUTPut] ?
Explanation: Sets/queries the output state immediately after power on.
Parameter:
POFF (Power off)
PON (Power on)
LAST (Outpu t state at power off)
Response: Returns any of POFF, PON, and LAST.
ex) SYS T:PO N?
POFF
・:OUTPut:IMPedance {0|1}
:OUTPut:IMPedance?
Explanation: Sets/queries the load impedance for converting the amplitude/DC offset
(Hi/Lo level) display value.
Parameter:
0 (open)
1 (50 Ω)
Response: Returns 0 or 1.
ex) OUTP:IMP?
1
・:SYSTem:ERRor?
Explanation: Queries the error state.
Parameter: None
Response: Returns the error number. Returns 0 if no error occurred.
Error Number
 “6.1.2 Errors of Remote Control via USB”