NF DF 1906 - Page 63

5.3 Explanation of Commands
DF1906
5-13
・:TRIGger[:SEQuence]:SLOPe {POSitive|NEGative}
:TRIGger[:SEQuence]:SLOPe?
Explanation: Sets/queries the slope where the trigger input is validated.
Parameter:
POSitive (Rise)
NEGative (Fall)
Response: Returns POS or NEG.
ex) TRIG:SLOP?
POS
・[:SOURce]:BURSt:GATE:POLarity {NORMal|INVerted}
[:SOURce]:BURSt:GATE:POLarity?
Explanation: Sets/queries the level where the gate input is valida ted.
Parameter:
NORMal(HIGH)
INVerted(LOW)
Response: Returns NORM or INV.
ex) BURS:GATE:POL?
NORM
・:OUTPut[:STATe] {OFF|ON}
:OUTPut[:STATe]?
Explanation: Sets/queries the output on/off.
Parameter:
OFF (Output off)
ON (Outpu t on)
Response: Returns 0 (OFF) or 1 (ON).
ex) OUTP?
1
・:MEMory:STATe:DELete
Explanation: Initializes the selected setting memory.
Parameter: None