22
4. BASIC OPERATION
MULTIFUNCTION GENERATOR
4.1.2 Restoration of settings at power-on
When the power is switched on/off with the power switch, the settings before the previous
time the power was switched off are restored when the power is switched on again.
The output on/off settings at power-on can be set on the Utility screen. ) p. 41
However, if the power supply to the equipment is directly cut off while the equipment's
power is on, the settings are set to the contents of setting memory 1 when the equipment is
powered on again.
a) Restoration of settings when power switch is switched on/off while power supply
is connected
The most general case is illustrated below.
While the equipment power is off, even if the power supply is cut off due to the disconnection of
the cord or the shutoff of a connected breaker, this has no influence on the restore operation
the next time the equipment is powered on again.
Power supply connected
Settings
AAA
Settings
AAA
㨪LINE
Power on state
Power supply disconnected
The power remains off
Power supply
reconnected
㨪LINE
㨪LINE
The power remains off
(standby state)
Power supply connected
㨪LINE
The power is switched on
(former settings are restored)
Power supply connected
1
㨪LINE
The power is switched off
(standby state)
2
1
2
Press the power switch.
Press the power switch.
Even if the
power supply is
disconnected in
the power off
state, this has
no influence on
the next restore
operation.
To Next Page
Loading...
