Nibe FIGHTER 1140 - Service Menus; Settings Additional Heat

Control
FIGHTER 1140
52
Menu 8.3.7 Return
Pressing the enter button returns you to menu 8.3.0.
Return
8.3.7
Menu 8.3.6 EBV value
The transfer value must be defined depending on the
current transformers used for the EBV card. The value
is adjustable between 100 and 900 in increments of
10. The setting 300 applies for the supplied current
transformers.
300
EBV value
8.3.6
U
Other settings
Settings additional heat
Menu 9.1.1 Start BIN 3 step
Degree-minute deficiency before additional heat is
engaged. When the power step has reduced the
degree-minutes deficiency by 100 in relation to the set
start value it is disengaged. The value is adjustable
between -30 and -500.
-400
Start BIN 3 step
9.1.1
S
Menu 9.1.0 Add. heat settings
Settings regarding additional heat in the heat pump
are made from the sub-menus to this menu. Applies to
docking options 1, 2 and 4.
Add. heat settings
9.1.0
S
Menu 8.5 Return
Pressing the enter button returns you to menu 8.0.
Return
8.5
Menu 8.4.5 Return
Pressing the enter button returns you to menu 8.4.0
Return
8.4.5
Menu 8.4.1 Pooltemp./Setting
The temperature when pool heating is stopped is stat-
ed here.
The value is adjustable between 5 and 55 °C.
19.0 (20)°C
Pooltemp./Setting
8.4.1
Menu 8.4.2 Diff. Pool/min-temp
The difference from the value in menu 8.4.1 when
pool heating starts is stated here.
The value is adjustable between 0.5 and 9.5 °C.
1.5°C
Diff. Pool/min-temp
8.4.2
Menu 8.4.3 Pool Time
The maximum time that pool heating can run is stated
here. The value is adjustable between 5 and 60 min-
utes.
20 min
Pool Time
8.4.3
U
U
U
Menu 8.4.5 Pool heating
The pool heating function can be activated or deacti-
vated here.
Off
Pool heating
8.4.5
U
Menu 8.4.0 Pool adjustments
Pool settings are made in the submenus to this menu.
Pool adjustments
8.4.0
U